The cards I have to share with you today are very similar to yesterday’s design – I’ve just added a few more elements to each of them.
For this card I added a layer of paper from the Bloom Where You’re Planted 12″x 12″ Designer Series Paper and stamped the images directly onto it.
Using two lengths of Linen Thread, I ied a double bow and attached it to the pot using a Mini Glue Dot.
I used the same DSP paper and stamped the images. Then I wrapped several lengths of Linen Thread around the DSP before tying a bow.
This time I chose a different piece of paper from the Bloom Where You’re Planted DSP. I stamped the greeting directly on the paper.
The three pots and cactii were stamped on a piece of Basic White cardstock and fussy cut them. Then I added them to the card front at three different levels, using Stampin’ Dimensionals.
Finally, I added some Pebbles Enamel Shapes to give the card a bit of bling.
This card features more layers and embossing. I used the Thanks Folder from the Thanks & Hello Embossing Folders.
After I added the greeting panel to the embossed layer, I took several lengths of Linen Thread and white baker’s twine, from the Baker’s Twine Essentials Pack, and wrapped it around and tied a bow.
This pot and cactus were stamped and punched using the Cactus Builder Punch.
Now to find some photos for tomorrow’s Memories on Monday project share.
Until then, happy stamping.
If you live in Australia, you can order any of the products I used to make this card by going to my online store. Just click on any of the images below.
 |  |  | ||
 |  |  | ||
 |  |  |  |  |
