Here are the final four cards I made to feature each of the 12 designs from the Botanical Textures DEsigner Series Paper.
It has been an interesting creative challenge to use each of the 12 paper designs to make 12 different cards.
For this card I cut a Basic White panel using one of the dies from the Grow with Love Dies.
I cut the black stem with one of the Memorable Blooms Dies. There was Adhesive Sheet on the back of the Basic Black card making it so easy to attach the stem to the card.
The same greeting panel was used again and I added more of the black dots to the card front.
Finally, I tied a small bow using the white twine from the Baker’s Twine Essentials Pack. The bow was attached with a Mini Glue Dot.
For this card I hand tore a wedge from the DSP, exposing the white ‘centre’ of the paper.
After glueing the DSP onto the Basic Black panel, I coloured a length of white baker’s twine using the Dark Smoky Slate Blends Pen. The twine was wrapped around the panel and tied off.
I used the largest banner die, from the Stylish Shapes Dies, to cut the DSP into four horizontal banners.
After they were adhered to the Basic Black layer I wrapped a length of White Woven Ribbon around the panel and tied a bow. I popped a Mini Glue Dop under the bow to secure it.
The Grow with Love Die was used to cut the panel in the centre of the DSP.
I took a length of white twine and untwisted it to create single threads that were then looped around the back of the greeting panel.
I used the Neutrals Matte Dots again for this card.
All 12 cards had strips of the same DSP attached to the card insert and back of the envelope.
Tomorrow I have a 3D project to share with you.
Until then, happy stamping.
If you live in Australia, you can order any of the products I used to make this card by going to my online store. Just click on any of the images below.
 |  |  | ||
 |  |  |  |  |
 |  |  | ||
 |  |  |  |  |
 |  |  |
